Initial SetupUpdated 5 months ago
- Slide open the box to access the face jewelry.
- Remove the pull tab in the battery pack.
- To turn on, press and HOLD the power button for 3 seconds.
- Click the button to cycle through the LED light sequences.
- Pick your desired lights placement for styling.
- Apply the latex free adhesive to the back of your LED shapes, wait until tacky, and then adhere them to your skin. (note any eyelash glue adhesive will work)
- Insert the silver clip through the loop on the battery pack and use it to clip the battery pack into your hair or to hide it in your clothes.
- To turn it off, press and hold the power button.
Styling Idea & Setup Demo
Plugging in the Connectors
On each side of the white silicone cover, where the connector goes, there is a little triangle indicating where to line up the connector.
Line up the outer most pin on the connector with the tip of the triangle and the other 2 pins should fall into place correctly. All 3 pins should line up, be sure not to miss a pin when inserting.
Do this on both sides and you’re set!
Replacing Your Battery
First, remove the included hair clip.
Snap it closed so it is flat.
Insert the tip into one of the slits in the silicone cover.
Slide it up until you find the edge of the metal battery holder.
Tuck the tip of the hair clip under the edge of the metal battery holder and press the hair clip firmly into the slot to push the dead battery out.
Insert the new battery with the plus side facing the slits in the silicone cover.
Check your work by pressing and holding the power button to turn on your lights.
Congrats! You're all set!
How Long Will My LED Face Jewelry Last and What Batteries Do I Need?
Your LED Face Jewelry will last over 10 hours with a fresh battery.
When it is time to get new batteries, they take CR2032 watch batteries which can be found through our affiliate link here.
